Accord Wagon EX L4-2156cc 2.2L SOHC (VTEC) MFI (1997)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Removal and Installation
WARNING:
-
The modulator unit contains high-pressure brake fluid. Be sure to drain the high-pressure brake fluid completely from modulator unit
before performing the modulator function check, disposing of the modulator unit, or replacing ABS pump motor.
-
Do not loosen the relief plug on the accumulator.
CAUTION:
-
When removing the modulator unit or after removing it, be careful not to turn it upside down or lean it excessively.
-
Do not spill brake fluid on the vehicle; it may damage the paint if brake fluid does contact the paint, wash it off immediately with water.
-
Take care not to damage or deform the brake lines during removal and installation.
-
To prevent the brake fluid from flowing, plug and cover the hose ends and joints with a shop towel or equivalent material.
REMOVAL
Modulator Remove & Install
-
Relieve ABS system pressure. See: Relieving System Pressure
-
Disconnect the modulator unit 14P connector and pump motor 2P connector.
-
Remove the wire harness clip from the modulator bracket.
-
Remove the three 8 mm nuts, and remove the modulator unit from the bracket.
INSTALLATION