Accord Wagon EX L4-2156cc 2.2L SOHC (VTEC) MFI (1997)
Snap Ring Removal & Installation
12. Install the circlip in the groove, then remove the special tool.
NOTE: Check that the circlip is seated in the groove properly.
13. Coat a new piston seal with recommended silicone grease in the caliper seal set, and install it in the caliper.
Grease The Caliper
14. Apply rubber grease to the sealing lips and inside of a new piston boot, and install it in the caliper.
CAUTION: Avoid damaging the piston and piston boot.
Piston Installation
15. Coat the outside of the piston with brake fluid, and install it on the adjusting bolt while rotating it clockwise with the special tool.