Accord Wagon EX L4-2156cc 2.2L SOHC (VTEC) MFI (1997)
Brake Caliper: Service and Repair
Rear
Akebono Calipers
WARNING:
-
Never use an air hose or dry brush to clean brake assemblies.
-
Use an OSHA-approved vacuum cleaner to avoid breathing brake dust.
-
Contaminated brake discs or pads reduce stopping ability.
-
When reusing the pads, always reinstall the brake pads in their original positions to prevent loss of braking efficiency.
CAUTION:
-
Do not spill brake fluid on the vehicle it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
-
Clean all parts in brake fluid and air dry; blow out all passages with compressed air. Before reassembling, check that all parts are free of dust and
other foreign particles.
-
Replace parts with new ones whenever specified to do so. Make sure no dirt or other foreign matter is allowed to contaminate the brake fluid.
-
Always use Genuine Honda DOT 3 Brake Fluid. Using a non-Honda brake fluid can cause corrosion and decrease the life of the system.
REMOVAL
Caliper Shield
^ Remove the caliper shield.
Brake Cable Removal & Installation
^ Remove the lock pin and clevis pin. Remove the cable clip and disconnect the cable from the arm.
^ Remove the banjo bolt and two sealing washers.