Accord Wagon EX L4-2156cc 2.2L SOHC (VTEC) MFI (1997)
13. Pull the knuckle outward, and remove the driveshaft outboard joint from the front wheel hub using a plastic hammer.
INSTALLATION
1. Install the outboard joint into the knuckle.
2. Apply 0.3 - 1.0 g (0.01 - 0.04 oz) of specified grease to the whole splined surface of the left driveshaft (for cars with intermediate shaft).
3. Install the new set ring onto the driveshaft groove.
CAUTION: Always use a new set ring whenever the driveshaft is being installed.
4. Insert the inboard end of the driveshaft into the differential or intermediate shaft until the set ring locks in the groove.