Civic L4-1.3L Hybrid (2008)
damage or deform the valve stem grommet.
3. Tighten the valve stem nut to the specified torque while holding the tire pressure sensor.
NOTE:
^
Do not use air or electric impact tools to tighten a valve stem nut.
^
Do not twist the tire pressure sensor to adjust its position with the wheel, as this will damage or deform the valve stem grommet.
4. Lube the tire bead sparingly, and position the wheel so that the tire machine (A) and the tire iron (B) are next to the valve stem (C) and will move
away from it when the machine starts. Then install the tire onto the wheel.
5. With a dry air source, inflate the tire to 300 kPa (3.1 kgf/cm2, 44 psi) to seat the tire bead to the rim, then adjust the tire pressure, then install the
valve stem cap.
NOTE: Make sure the tire bead is seated on both sides of the rim uniformly.
6. Check and adjust the wheel balance, then install the wheels on the vehicle.
7. Remove the jack stands, and lower the vehicle. Torque the wheel nuts to specifications.
8. Connect the HDS, and memorize the tire pressure sensor IDs using the TPMS sensor initializer tool.
