Civic L4-1.3L Hybrid (2008)
Axle Shaft Assembly: Overhaul
Driveshaft Disassembly
Driveshaft Disassembly
Special Tools Required
^
Threaded adapter, 22 x 1.5 mm 07XAC-001010A
^
Slide hammer, 5/8"-18 UNF, commercially available
^
Boot band pliers, commercially available
^
Puller, commercially available
Inboard Joint Side
1. Remove the set ring from the inboard joint.
2. Remove the boot bands. Be careful not to damage the boot.
^
If the boot band is a welded type (A), cut the boot band.
^
If the boot band is a double loop type (B), lift up the band end (C), and push it into the clip (D).
^
If the boot band is a low profile type (E), pinch the boot band using commercially available boot band pliers (F).
