Civic L4-1.8L (2006)
13. Apply primer to the molding (A), then attach the molding upper seal (B) with adhesive tape to the inside surface of the molding as shown.
14. Attach the lower rubber dam (A) with body side adhesive tape to the body as shown. Do not peel the glass side adhesive backing.
15. Set the windshield in the opening, and center it. Make alignment marks (A) across the windshield and body with a grease pencil at the four points
shown. Make sure both clips (B) contact with the edge of the body holes. Be careful not to touch the windshield where adhesive will be applied.
16. Remove the windshield.