Civic L4-1.8L CNG (2008)
Tire Pressure Sensor: Testing and Inspection
Tire Pressure Sensor Location
Tire Pressure Sensor Location
Special Tools Required
TPMS sensor initializer tool AKS0620006
Available through the American Honda Tool and Equipment Program; call 1-888-424-6857
NOTE: This procedure locates where the tire pressure sensors number 1, 2, 3, 4 are mounted, when activated by the TPMS sensor initializer tool.
^
Memorizing tire pressure sensor IDs (including replacing the TPMS control unit, or the tire pressure sensors).
^
Wheel rotation.
1. With the ignition switch at LOCK (0), connect the HDS to the data link connector (DLC (A) located under the driver's side of the dashboard.
2. Turn the ignition switch to ON (II).
3. Make sure the HDS communicates with the vehicle and the TPMS control unit. If it doesn't, troubleshoot the DLC circuit.
4. Select Function Test from the mode menu, then select Sensor Position Check on the HDS.
5. Follow HDS screen prompts to turn on the TPMS sensor initializer tool (A). Verify the power switch (B) is in the "Low" position.
6. Follow the prompts on the HDS to activate the tire pressure sensors using the TPMS sensor initializer tool. Start with the left-front (LF) wheel.