Civic L4-1.8L CNG (2008)
9. Remove the flange bolt (D), and remove the knuckle.
NOTE: Use the new flange bolt during reassembly.
10. Install the knuckle in the reverse order of removal, and note these items:
^
First install all the components, and lightly tighten the bolts and nuts, then raise the suspension to load it with the vehicle's weight before fully
tightening to the specified torque values.
^
Align the cam positions of the adjusting bolt and the adjusting cam plate with the marked positions when tightening.
^
Before installing the wheel, clean the mating surfaces of the brake disc and the inside of the wheel.
^
Check the wheel alignment, and adjust it if necessary.
Knuckle Replacement-Drum Brake Type
1. Remove the hub bearing unit.
2. Disconnect the brake line (A) from the wheel cylinder (B). Remove the backing plate (C) with brake shoes assembly from the knuckle.
3. Remove the wheel speed sensor (A), and the brake hose mounting bracket (B) from the knuckle (C). Do not disconnect the wheel speed sensor
connector.