Civic L4-1.8L CNG (2008)
14. Disconnect one of the jumper wires and check the valve movement at the fluid passage in the valve body mounting surface. If the valve binds or
moves sluggishly, or if the solenoid valve does not operate, replace A/T clutch pressure control solenoid valve A.
15. Clean the mounting surfaces and fluid passages of the solenoid valve body and the transmission housing.
16. Install a new gasket with the blue side down and the white side up on the transmission housing, and install the ATF pipe and the ATF joint pipes.
17. Install new O-rings over the ATF joint pipes.
18. Install A/T clutch pressure control solenoid valve A.
19. Check the connectors for rust, dirt, or oil, clean or repair if necessary, then connect the connectors securely.
20. Secure the harness cover with the mounting bolts, and install the harness clamp.
21. Install the intake air duct and the air cleaner assembly.
