Civic L4-1493cc 1.5L SOHC (VTEC) (1993)
46.
Install the terminals in the new plastic connector. Install the new terminal lock.
47.
Apply a generous amount of lithium dielectric grease to the back of the connector with a putty knife.
48.
Apply a small amount of the same grease to the front of the connector; use just enough grease to coat the terminals.
49.
Install the boot over the connector. Tape the boot to the plastic tube with the insulating tape.
50.
Feed the harness back through the speaker opening. Install the connector in the door edge.
51.
Reconnect the body side of the door harness connector to the door side. Make sure it is fully connected and locked in place.
52.
Reconnect the connector to the speaker. Install the speaker mount.
53.
Reinstall the door panel.
54.
Connect the battery. Test the operation of the power windows, power door locks, power mirrors, and left door speakers.
55.
Enter the audio system security code, if needed. Enter the customer's radio station presets.
REQUIRED MATERIALS
19 mm Insulating Tape: