Civic L4-1590cc 1.6L SOHC (VTEC) (1992)
27.
Slide the two boot halves over the corrugated tube. Wrap the joint with insulating tape.
28.
Remove the tape from the terminals. Thoroughly clean the terminals with contact cleaner.
29.
Install the terminals in the proper locations in the new plastic connector from the kit. Install the terminal lock.
30.
Apply a generous amount of lithium dielectric grease (see REQUIRED MATERIALS) to the back of the connector with a putty knife.
31.
Apply a small amount of the same grease to the front of the connector; use just enough grease to coat the terminals.
32.
Install the boot around the connector. Feed the harness back through the hole in the A pillar.
33.
Install the bracket and cruise control unit.
34.
Install the door, hinge pins, and door detent pin.