honda Workshop Repair Guides

Honda Workshop Service and Repair Manuals

Engine Difficult to Start When Cold|Page 3274 > < Engine Difficult to Start When Cold|Page 3272
Page 1
background image

Idle Speed/Throttle Actuator - Electronic: Testing and Inspection

Engine Difficult to Start When Cold

Check:

1. Coolant Temperature (TW) Sensor (6)
2. Fast Idle Valve
3. Manifold Absolute Pressure (MAP) Sensor (3)(5)
4. TDC/CRANK/CYL Sensor (4)(8)(9)
5. Atmospheric Pressure (PA) Sensor (13)
6. Electronic Control Unit (ECU) (BU)

NOTE: 
After each symptom, the system that could be the source of the symptom are listed and should be checked in the order they are listed, beginning
with #1.

(BU) code used when the CHECK ENGINE warning light is on.  Jump the service check connector, if no code is displayed (CHECK ENGINE
LIGHT stays on steady), the back-up system is in operation.

Self-diagnosis indicator, (CHECK ENGINE LIGHT) blinks (?), will follow associated systems.

Fast Idle Out of Specification When Cold

Check: 

1. Electronic Air Control Valve (EACV) (14)
2. Other Idle Controls

a. Fast Idle Valve
b. Idle Adjusting Screw

3. Coolant Temperature (TW) Sensor (6)
4. Electronic Control Unit (ECU) (BU)

NOTE: 
After each symptom, the system that could be the source of the symptom are listed and should be checked in the order they are listed, beginning
with #1.

(BU) code used when the CHECK ENGINE warning light is on, and the self-diagnosis indicator LED is ON with no "blinks", the back-up system
is in operation.

Frequent Stalling After Warm Up

Check: 

1. Idle Control System

a. Electronic Air Control Valve (EACV) (14)
b. Idle Adjusting Screw

2. Fuel Supply

a. Injector Resistor
b. Fuel Injector
c. Contaminated Fuel

3. Exhaust Gas Recirculation (EGR) Control System (12)
4. Atmospheric Pressure (PA) Sensor (13)
5. PGM-FI Control (ECU) Unit (BU)

NOTE: 
After each symptom, the system that could be the source of the symptom are listed and should be checked in the order they are listed, beginning
with #1.

(BU) code used when the CHECK ENGINE warning light is on.  Jump the service check connector, if no code is displayed (CHECK ENGINE
LIGHT stays on steady), the back-up system is in operation.

Self-diagnosis indicator, (CHECK ENGINE LIGHT) blinks (?), will follow associated systems.

Frequent Stalling During Warm Up

Check: 

Engine Difficult to Start When Cold|Page 3274 > < Engine Difficult to Start When Cold|Page 3272