Civic L4-1590cc 1.6L SOHC (VTEC) (1992)
b. Install the thrust washer and spring washer in the mainshaft.
c. Install the mainshaft in the clutch housing.
d. Place the transmission housing over the main- shaft and onto the clutch housing.
e. Tighten the clutch and transmission housings with several 10 mm bolts.
f.
Tap the mainshaft with a plastic hammer.
7. Check the thrust clearance in the manner described below.
CAUTION: Measurement should be made at room temperature.
a. Slide the mainshaft base and the collar over the mainshaft.
b. Attach the mainshaft holder to the mainshaft as follows:
-
Back-out the mainshaft holder bolt and loosen the two hex bolts.
-
Fit the holder over the mainshaft so its lip is towards the transmission.
-
Align the mainshaft holder's lip around the groove at the inside of the mainshaft splines, then tighten the hex bolts.
c. Seat the mainshaft fully by tapping its end with a plastic hammer.
d. Thread the mainshaft holder bolt in until it just contacts the wide surface of the mainshaft base.