Civic L4-1590cc 1.6L SOHC (VTEC) (1992)
3.
Remove the run channel seal from the area shown.
4.
Protecting the body with a shop towel, clean the run channel and the run channel seal with contact cleaner.
5.
Apply a thin coat of 3M Weatherstrip Adhesive (P/N 051135-08011) to the indentation in the run channel and to the back of the run channel seal.
NOTE:
Do not use 3M Super Weatherstrip Adhesive. It does not stick to Honda weatherstrip.
6.
Wait until the adhesive is tacky, then reinstall the run channel seal.
NOTE:
If you apply the adhesive too thickly or do not allow enough time for the adhesive to become tacky, the weatherstrip does not adhere to the door sash.
7.
Wait for five minutes to allow the adhesive to dry completely.
8.
Close the window, and check the fit of the run channel seal.
NOTE:
If you apply the weatherstrip adhesive carefully, cleanup is minimal. Remove any traces of weatherstrip adhesive with 3M Adhesive Cleaner (P/N
051135-08904).
9.
Reinstall the mirror, and check for proper mirror operation.
WARRANTY CLAIM INFORMATION
In warranty:
The normal warranty applies.
Out of warranty:
Any repair performed after warranty expiration may be eligible for goodwill consideration by the District Service Manager. You must request
consideration, and get the DSM's decision, before starting work.
Operation number:
835705
Flat rate time: