Civic CVCC L4-1488cc 1500 EM1 (1982)
above.
CAUTION: Failure to use the wood block could cause the hole saw pilot drill bit to damage the anchor nut threads or the sheet metal.
7.
Drill a hole through the trim panel with a 1 hole saw, using the raised dimple to center the hole.
8.
Reinstall the "C" pillar trim panel.
9.
Attach the shoulder belt to the anchor point in the "C" pillar, then attach the shoulder belt to the lap belt tongue plate.
Torque:
32 N-m (3.2 kg-m, 23 lb.ft.)
10.
Perform the preceding steps on the other side of the car.
SPECIAL TOOL MANUFACTURING
WARNING:
Do not use a galvanized bolt or galvanized threaded metal stock to make this tool. Galvanized metal produces harmful gases when
welded.
1.
Cut off the head of a SAE 7/16" fine thread bolt, leaving about 7/8" thread after cutting.
2.
Grind or machine a steep point of approximately 45~ onto the end of the bolt where the head was cut off.
3.
Install a nut onto the threaded section of the bolt so it is flush with the base of the point, then tack weld it onto the bolt.
NOTE:
Save the special tool for future installations of lap/shoulder rear seat belts.
PARTS INFORMATION Rear Seat Belt Set:
NOTE:
2 rear seat belt sets per car (1 set per side) are required.
Year
Model
H/C
P/N
Civic
84-85 3-dr S*
2774487 78630-SB3-305
86-87 3-dr Si* " "
86-87 3-dr DX* " "