Civic DX Sedan L4-1590cc 1.6L SOHC MFI (1999)
![background image](/honda/civic_dx_sedan/l4-1590cc_1.6l_sohc_mfi/Page-1805004.png)
1. Inspect the ball bearing by rotating the outer race slowly. If any play or roughness is felt, replace the ball bearing.
2. Remove and discard the ball bearing using a press as shown.
3. Install the new ball bearing using a press as shown.
Ball Bearing Replacement:
Reassembly
1. Align the pin of the sub-valve with the oil passage in pump housing, and push down the sub-valve. Install the snap ring properly.
2. Install the new pump seal in the pump housing by hand, then install the pump seal spacer.
NOTE: Insert the pump seal with its grooved side facing in.