Civic Hatchback L4-1.5L SOHC (VTEC) (1995)
1.
Remove the door panel. (Refer to section 20 of the appropriate Civic Service Manual.)
2.
If you are working on a front door panel, remove the power window switch.
3.
Cover your workbench with a protective cloth, then place the door panel upside down on the cloth.
4.
While wearing eye protection, drill a 5/16-inch hole through the center of each heat-bonded boss. (The bosses attach the center pad to the door
panel.) Front door center pads have 14 bosses; rear door center pads have 17.
5.
Pull off and discard the pad. If needed, use a pair of diagonal cutters to remove any material remaining on the bosses.