Civic Hatchback L4-1.5L SOHC (VTEC) (1995)
/Page-1472004.png)
11.
To drive the outboard joint on the rest of the way, pick up the assembly and let it fall from about 10 cm (4 to 5 in.) onto a hard surface.
NOTICE
Do not use a hammer; excessive force may damage the driveshaft.
12.
Measure distance "A" (from the splines to the inner race of the joint). If the distance is more than your measurement in Step 3, repeat Step 11.
13.
When distance "A" equals your measurement in Step 3, the "C" clip should be seated in the joint. Tap on the inner race with a plastic hammer to
make sure the joint does not move on the driveshaft.
14.
Fit the small end of the boot into the boot groove on the driveshaft.
15.
Install the small boot band provided in the kit. Bend both sets of locking tabs over, then lightly tap them flat.
16.
Pack the outboard boot with the grease included in the kit. Pack the outboard joint with the remaining grease, then fit the boot over the outboard
joint.
17.
Install the large boot band provided in the kit. Bend both sets of locking tabs over, then lightly tap them flat.
18.
Reinstall the driveshaft assembly into the car. Refer to Section 16 of the appropriate service manual.
Disclaimer
