Civic Hatchback L4-1.5L SOHC (VTEC) (1995)
Air Bag: Service and Repair
Passenger Airbag Replacement
REMOVAL
1. On models equipped with radio coded theft protection system, refer to Vehicle Damage Warnings for system disarming and arming
procedures. On models equipped with airbag system, refer to Technician Safety Information for system disarming and arming procedures.
2. Disconnect battery negative cable, then positive cable.
3. Remove glove compartment and access panel.
4. Remove six air bag assembly mounting nuts.
Fig. 28 Passenger Side Air Bag Mounting
4. Carefully lift air bag assembly from instrument panel, Fig. 28.
INSTALLATION
1. Position the air bag assembly in the instrument panel, then install six mounting nuts, Fig. 28. Do not tighten the mounting nuts at this time.
2. Tighten the upper four mounting nuts, then the two lower mounting nuts to specifications. The lower mounting brackets are adjustable and can be
used to properly position the air bag assembly.
3. Install the access panel and glove compartment.
4. Reconnect battery positive cable, then negative cable.
5. After completing installation, place ignition switch in On position. SRS indicator lamp should be illuminated for approximately six seconds, then
lamp should turn off. If lamp remains illuminated or does not illuminate, a problem in the SRS is indicated.
6. If vehicle is equipped with radio theft protection, place radio control knob in On position. When the word Code appears on the radio display panel,
enter the five-digit radio theft protection code number.