Civic Sedan L4-1.5L SOHC (16 valve) (1995)
5. Remove the two mounting bolts. Loosen the mounting bolt and three motor bolts. Disconnect the connector (power window model). Remove the
regulator through the center hole in the door.
6. Grease all the sliding surfaces of the regulator where shown. Check that the regulator moves smoothly by connecting the regulator handle or a 12
V battery to the power window motor.
7. Installation is the reverse of the removal procedure.
8. Roll the glass up and down to see if it moves freely without binding. Also make sure that there is no clearance between the glass and glass run
channel when the glass is closed. Adjust the position of the glass as necessary.
9. Attach the door harness to the door correctly.
10. When reinstalling the plastic cover, apply adhesive along the edge where necessary to maintain a contentious seal and prevent water leaks.