Civic Sedan L4-1.6L SOHC (VTEC) (1996)
8.
Using the sequence shown, tighten the five 6 mm nuts on the fuel gauge sending unit to 5.9 Nm (4.3 lb-ft).
9.
Connect the negative cable to the battery, then turn the ignition switch ON.
^
If the fuel gauge reads empty, reinstall the drain plug with a new 12 mm sealing washer (see PARTS INFORMATION), and continue to step
10.
^
If the fuel gauge reads full, replace the fuel tank with the one listed under PARTS INFORMATION. (Refer to page 11-148 of the Service
Manual.)
10.
Turn the ignition switch OFF, and fill the fuel tank. Turn the ignition switch ON.
^
If the fuel gauge reads full, continue to step 11.
^
If the full gauge does not read full, replace the fuel tank with the one listed under PARTS INFORMATION. (Refer to page 11-148 of the
Service Manual.)
11.
Check for any fuel leaks around the fuel sending unit.
12.
Reinstall the access panel and the rear seat cushion.
13.
If applicable, enter the customer's radio station presets and reset the clock.
PARTS INFORMATION
Fuel tank:
P/N 17500-S01-A30, H/C 4810339
Sealing washer, 12 mm:
P/N 94109-12000, H/C 0171868
WARRANTY CLAIM INFORMATION
In warranty:
The normal warranty applies.
Out of warranty:
Any repair performed after warranty expiration may be eligible for goodwill consideration by the District Service Manager or your Zone Office. You
must request consideration, and get a decision, before starting work.