Civic Sedan L4-1488cc 1.5L SOHC (D15A2) 3V Carb (1987)
Transmission Cooler: Technical Service Bulletins
A/T - Cooler Flushing Procedure
Bulletin No.
89-022
Issue Date
JULY 28, 1989
Model
ALL
Applicable To
ALL
File Under
TRANS
A/T Cooler Flushing Procedure
When an automatic transmission has been overhauled or is replaced for any reason, the cooler must be flushed to eliminate system contamination.
REQUIRED TOOL INFORMATION
A/T Transmission Cooler Flusher:
J 38405-A
Biodegradable Transmission Cooler Flushing
Fluid: J 35944-20
CORRECTIVE ACTION
Flush the transmission cooling system using the following procedure:
[WARNING] Transmission fluid can cause serious eye injury. Always wear safety glasses or a face shield when using the transmission flusher. For eye
and skin contact, flush with water immediately.
1.
Check the flusher and hoses for wear or cracks. If found, replace before using.
2.
Use the measuring cup and fill the tank with 21 ounces of J35944-20 biodegradable flushing fluid (supplied with tool).
NOTE:
Do not substitute any other fluid and follow the handling procedure on the fluid container.
3.
Secure the filler cap and pressurize the tank with 80-120 psi of shop air.
NOTE:
The air hose should be equipped with a water trap to ensure a dry air system.
4.
Use the hanger located in front of the water valve and hang the flusher under the car.