Civic Si L4-2.0L (2004)
6.
Cut the trunk lid RED/YEL wire 50 mm past the hinge harness clip location as shown.
7.
Cut 100 mm from the ends of two of the three body side RED/YEL wires.
8.
Strip 7 mm of insulation from the ends of the RED/ YEL wires, and from the 300 mm wire in the splice repair kit.
9.
Insert the two shortened body side wires into one side of the blue splice connector, then insert the 300 mm wire and the longer body side wire into
the other side of the connector. Crimp both ends of the connector.
10.
Insert the other end of the 300 mm wire into one side of the red splice connector, then insert the trunk lid RED/YEL wire into the other side.
Crimp both ends of the connector.
11.
Use a heat gun to shrink the insulation on the splice connectors until sealant comes out from the ends of the connectors.
NOTE:
Use a non-flammable insulating material to protect the other wires from heat.