CR-V EX 4WD L4-1972cc 2.0L DOHC MFI (2000)
Spray : 2-3 coats.
-
Use the following materials:
-
615S Primer Surfacer (DuPont)
-
Primer Surfacer EP (Akzo)
-
NPS735 Urethane Primer Surfacer (R-M)
-
Spies Hecker Permacron HS Surfact (Hoechst)
-
Standox 2K HS Filler (Herberts)
-
Let the primer air dry for 5-10 minutes, then force dry with a infrared lamp.
NOTE: Keep the dryer 40-50 cm (16-20 in) from the surface.
9. Application of Polishing Undercoat
-
Remove the masking paper and tape.
-
Check that the undercoat has dried thoroughly, then dry or wet sand the surface with a 1280 or #320 sand paper.
NOTE:
-
Use a rubber block and sand flat and smooth.
-
Sand the entire surface to be refinished.
10. Air Blowing/Degreasing
WARNING:
-
Do not use high air pressure: use only an approved, 210 kPa (2.1 kgf/sq.cm, 30 psi) air nozzle.
-
Wear goggles or safety glasses to prevent eye injury.
-
Blow all the surfaces with compressed air then degrease with a wax and grease remover.
-
Use the following materials:
-
38125 Enamel Reducer (Dupont)
-
Spies Hecker Silicon Remover (Hoechst)
-
Standox Silicon Remover (Herberts)
NOTE: Also degrease the surfaces where masking tape will be attached.
11. Masking
Mask the undamaged areas surrounding the damage to prevent overspray from primer surfacer (undercoat).
NOTE: Use masking tape and paper to mask the body. A vinyl cover may also be used to effectively mask the body.
12. Application of Intermediate Coat (same color as enamel) top coat spraying/drying
WARNING:
-
Ventilate when spraying paint. Most paint contains substances that are harmful if inhaled or swallowed. Read the paint label before
opening the paint container.
-
Avoid contact with skin. Wear an approved respirator, gloves, eye protection, and appropriate clothing when painting.
-
Paint is flammable. Store it in a safe place, and keep it away from sparks, flames, or cigarettes.
-
Use the same color paint as the top coat. Spray it over the surface until the undercoat (primer surfacer) is fully covered.
-
Spray the paint slightly thicker than normal to allow for loss during subsequent polishing.
-
Super ponacle II (R-M)
-
Super Centri (Dupont)
-
Auto cryl (Akzo)
-
Spies Hecker Permacron 2k Acrylic Top Coat (Hoechst)
-
Standox Standocryl 2K (Herberts)
13. Polishing of Intermediate Coat
-
Check that the paint coat has dried thoroughly, then dry or wet sand the surface with a #600 and #800 sand paper.
NOTE: Use a rubber block to sand flat and smooth, being careful not to expose the undercoat.
Polishing of Top Coat (if damaged):
Use the same technique described above.
14. Air Blowing/Degreasing