CR-V EX 4WD L4-1972cc 2.0L DOHC MFI (2000)
Fluid - Differential: Service and Repair
DIFFERENTIAL FLUID
WARNING: Make sure lifts are placed properly.
1. With the vehicle on level ground, inspect differential fluid with engine OFF.
2. Remove the oil filler plug, then check the level and condition of the fluid.
3. The fluid level must be up to the fill hole. If it is below the hole, add the recommended fluid until it runs out, then reinstall the oil filler plug with a
new washer.
4. If the differential fluid is dirty, remove the drain plug, and drain the fluid.
5. Clean the drain plug, then reinstall it with a new washer, and refill the differential with the recommended fluid to the proper level.
NOTE: If you disassembly the differential, check the fluid level again after the 4WD system check is finished. Add fluid if necessary.
6. Reinstall the oil filler plug with a new washer.
Fluid Capacity
1.0 L (1.1 US qt, 0.9 Imp qt) at fluid change
1.2 L (1.3 US qt, 1.1 Imp qt) at overhaul
Recommended fluid:
Genuine Honda CVT Fluid