CR-V EX 4WD L4-1972cc 2.0L DOHC MFI (2000)
Timing Belt: Service and Repair
Inspection
INSPECTION
1. Remove the cylinder head cover.
2. Inspect the timing belt for cracks and oil or coolant soaking. Replace the belt if it is oil or coolant soaked. Remove any oil or solvent that gets on
the belt.
3. After inspecting, retorque the crankshaft pulley bolt to 177 Nm (18.0 kgf.m, 130 ft. lbs.).
4. Install the cylinder head cover.
TENSION ADJUSTMENT
NOTE:
-
Always adjust the timing belt tension with the engine cold.
-
Always rotate the crankshaft counterclockwise when viewed from the pulley side. Rotating it clockwise may result in improper adjustment of the
belt tension.
1. Remove the cylinder head cover.
2. Set the No. 1 piston at TDC.
3. Rotate the crankshaft five or six revolutions to set the belt.
4. Set the No. 1 piston at TDC.
5. Loosen the adjusting bolt 1/2 turn (180°) only.