CR-V LX 2WD L4-1972cc 2.0L DOHC MFI (1998)
12. Install and tighten the retainer nuts.
13. Connect the vacuum hoses and fuel return hose to the fuel pressure regulator.
14. Connect the PCV valve.
15. Connect the connectors to the fuel injectors, the IAT sensor, and the EVAP purge control solenoid valve.
16. Coat new O-ring with clean engine oil, and install the resonator chamber.
17. Turn the ignition switch ON (II), but do not operate the starter. After the fuel pump runs for approximately two seconds, the fuel pressure in the
fuel line rises. Repeat this two or three times, then check whether there is any fuel leakage.