CR-V LX 2WD L4-1972cc 2.0L DOHC MFI (1998)
8. Install the SRS unit covers (right and left). Make sure the covers snap together in the middle.
9. Reconnect the driver's airbag 2P connector to the cable reel 2P connector, then reinstall the access panel on the steering wheel.
10. Reconnect the front passenger's airbag connector to the SRS main harness.
11. Reconnect the left side wire harness 2P connector to the driver's seat belt tensioner and the right side wire harness 2P connector to the front
passenger's seat belt tensioner.
12. Reinstall the center pillar lower trim panels.
13. Reconnect the battery positive cable, then the negative cable.
14. After installing the SRS unit, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator light should come on for about
six seconds and then go off.
