CR-V LX 2WD L4-1972cc 2.0L DOHC MFI (1998)
Air Bag Control Module: Service and Repair
CAUTION:
-
Before disconnecting any part of the SRS wire harness, disconnect the airbag connectors (and seat belt tensioner connectors).
-
During installation or replacement, do not bump (impact wrench, hammer etc.) the area near the SRS unit.
-
Do not damage the SRS unit terminals or connectors.
-
Do not disassemble the SRS unit; it has no serviceable parts.
-
Store the SRS unit in a clean, dry area.
-
Do not use any SRS unit which has been subjected to water damage or shows signs of being dropped or improperly handled, such as dents, cracks
or deformation.
1. Disconnected the battery negative cable, then disconnect the positive cable from the battery, and wait at least three minutes.
2. Disconnect the airbag connectors (and seat belt tensioner connectors). (When disconnected, the airbag and seat belt tensioner connectors are
automatically shorted.)
Driver's Side:
Remove the access panel from the steering wheel, then disconnect the 2P connector between the driver's airbag and cable reel.
Front Passenger's Side:
Disconnect the 2P connector between the front passenger's airbag and SRS main harness.
Seat Belt Tensioner:
Remove the left and right center pillar lower trim panels.
Disconnect the seat belt tensioner 2P connectors from the left side wire harness (driver's side) and the right wire harness (front passenger's side).
3. Remove the right side cover from the SRS unit.
