CR-V LX 4WD L4-1972cc 2.0L DOHC MFI (2000)
P/N 17012-S01-A00
H/C 5999016
ECM/PCM:
P/N 37820-P2P-A12
H/C 6104426
Defect Code:
072
Contention Code:
C01
Skill Level:
Repair Technician
Out of warranty:
Any repair performed after warranty expiration may be eligible for goodwill consideration by the District Parts and Service Manager or your Zone
Office. You must request consideration, and get a decision, before starting work.
REPAIR PROCEDURE
1.
Connect the PGM Tester to the 16P data link connector.
2.
Turn the ignition switch to ON (II). Turn on the PGM Tester.
3.
From the PROGRAM MENU screen, select HONDA SYSTEMS.
4.
From the SYSTEM SELECT screen, select 1: PGM-FI.
5.
From the TEST MODE MENU screen, select 6: INSPECTION.
6.
From the INSPECTION MENU screen, select 2: EVAP TEST.
7.
From the EVAP TEST MENU, select 1: SINGLE SOLENOIDS.
8.
From the SINGLE SOLENOIDS MENU, activate the EVAP bypass solenoid valve. Listen for a click and feel for a light tap from the solenoid
valve as you activate it.
^
If you can hear the solenoid valve click or feel it tap when activated, disregard this service bulletin, and look for other possible causes.
^
If you cannot hear the solenoid valve click or feel it tap when activated, go to step 9.
9.
Replace the EVAP bypass solenoid valve (see section 11 of the appropriate service manual).
10.
Test the new solenoid valve with the PGM Tester.
^
If you can hear the solenoid valve click or feel it tap when activated, go to step 15 or 16 as appropriate.
^
If you cannot hear the solenoid valve click or feel it tap when activated, go to step 11.
11.
Check the wire harness and the connectors for damage.
^
If you find any damage, repair it, then go to step 12.
^
If you find no damage in the wire harness or connectors, go to step 13.
12.
Test the solenoid valve again with the PGM Tester.
^
If you can hear the solenoid valve click or feel it tap when activated, go to step 15 or 16 as appropriate.
^
If you cannot hear the solenoid valve click or feel it tap when activated, go to step 13.
13.
Replace the ECM/PCM (see section 11 of the appropriate service manual).
14.
Use the PGM Tester to retest the solenoid valve.
^
If you can hear the solenoid valve click or feel it tap when activated, go to step 15 or 16 as appropriate.
