CR-V LX 4WD L4-1972cc 2.0L DOHC MFI (2000)
11. Remove the boot bands and outboard boot, then remove the vinyl tape.
12. Inspect the outboard joint for faulty movement and wear. If any roughness or excess play is felt, replace the outboard joint.
ASSEMBLE
NOTE:
-
Clean the disassembled parts with solvent, and dry them throughly with compressed air. Do not wash the rubber parts with solvent.
-
Thoroughly pack the inboard joint and both joint boots with the joint grease included in the new driveshaft set.
