CR-V LX 4WD L4-2.4L (2002)
6. To remove a rear drain valve (A) from the cargo area, remove these parts:
-
Rear side trim panel.
-
C-pillar trim.
Using a clip remover, detach the clips (B), then remove the rear drain tube (C).
7. Install the frame and drain tube in the reverse order of removal, and note these items:
-
Before installing the frame, clear the drain tubes and drain valves using compressed air.
-
Check the frame seal.
-
Clean the surface of the frame.
-
When installing the frame, first attach the rear hooks into the body holes.
-
Make sure the connector is plugged in properly.
-
When connecting the drain tube, slide it over the frame nozzle at least 10 mm (0.39 in.).
-
Install the tube clip (A) on the drain tube (B) as shown.
8. Check for water leaks. Let the water run freely from a hose without a nozzle. Do not use a high-pressure spray.