CR-V LX 4WD L4-2.4L (2002)
7.
Connect the SCS service connector to the 2P MES (memory erase signal) connector, as shown. Do not use a jumper wire.
8.
Turn the ignition switch to ON (II).
9.
Watch the SRS indicator. (It comes on for about 6 seconds and then goes off.) Disconnect the SCS service connector from the MES connector
within 4 seconds after the indicator goes off.
10.
When the SRS indicator comes on again, connect the SCS service connector to the MES connector within 4 seconds after the indicator comes on.
11.
When the SRS indicator goes off, disconnect the SCS service connector from the MES connector within 4 seconds.