CR-V LX 4WD L4-2.4L (2002)
20. Push the brushes (A) in, then insert a pin or drill bit (B) (about 1.8 mm (0.77 in.) diameter) to hold them there.
21. Heat the rear bearing seat with a 1,000 W hair drier for about 5 minutes (129 - 140 °F, 50 - 60 °C).
22. Put the rear housing assembly (A) and drive-end housing/rotor assembly (B) together, tighten the four through bolts (C) and pull out the pin (D).
23. After assembling the alternator, turn the pulley by hand to make sure the rotor rotates smoothly and without noise.
24. Install the alternator and drive belt.