CR-V SE 4WD L4-1972cc 2.0L DOHC MFI (2001)
Engine Control Module: Service and Repair
ECM/PCM Idle Learn Procedure
ECM/PCM Idle Learn Procedure
NOTE: The ECM/PCM reset procedure and disconnecting the battery or the No.6 ECU (ECM/PCM) (15 A) fuse cancels the ECM/PCM memory for
idle control. The following procedure is needed after the ECM/PCM reset procedure and reconnecting the battery or the No.6 ECU (ECM/PCM) (15 A)
fuse.
1. Start the engine. Hold the engine at 3,000 rpm with no load (in Park or neutral) until the radiator fan comes on.
2. Let the engine idle for approx. 5 minutes under the following conditions:
-
Transmission in Park or neutral
-
A/C switch OFF
-
Headlights OFF
-
Rear defogger OFF