CR-V SE 4WD L4-1972cc 2.0L DOHC MFI (2001)
Air Bag: Service and Repair
Driver Airbag
Spring-Loaded Lock Connector
Spring-loaded Lock Connector
Some SRS system connectors have a spring-loaded lock.
Front Airbag Connectors:
Disconnecting
To release the lock, pull the spring-loaded sleeve (A) toward the stop (B) while holding the opposite half of the connector. Then pull the connector
halves apart. Be sure to pull on the sleeve and not on the connector.
Connecting
1. To reconnect, hold the pawl-side connector, and press on the back of the sleeve-side connector in the direction shown. As the two connector halves
are pressed together, the sleeve (A) is pushed back by the pawl (C). Do not touch the sleeve.
2. When the connector halves are completely connected, the pawl is released, and the spring-loaded sleeve locks the connector.
Removal and Installation
Driver's Airbag Replacement
Removal
1. Disconnect the battery negative cable, and wait at least 3 minutes before beginning work.