CR-V SE 4WD L4-1972cc 2.0L DOHC MFI (2001)
18. Coat the O-ring with power steering fluid, and install it into the grooves in the inlet joint.
19. Install the inlet joint on the pump housing.
20. Install the pulley as shown below, then loosely install the pulley nut. Hold the steering pump in a vise with soft jaws. Be careful not to damage the
pump housing with the jaws of the vise.
21. Hold the pulley with the special tool, and tighten the pulley nut.
22. Check that the pump turns smoothly by turning the pulley by hand.
