CR-V SE 4WD L4-1972cc 2.0L DOHC MFI (2001)
Stabilizer Bar: Service and Repair
Rear
CAUTION: When the suspension arms are to be removed, place additional weight in the trunk before hoisting. When substantial weight is removed
from the rear of the vehicle, the center of gravity may change causing the vehicle to tip forward.
NOTE:
-
Replace the self-locking nuts after removal.
-
Any bolts or nuts connected to rubber mounts or bushings should be tightened with the vehicle on the ground.
-
Make sure the toe adjusting bolts on the compensator arm are installed in the same direction.
-
After installing the suspension arm, check the rear wheel alignment, and adjust if necessary.