CR-V SE 4WD L4-1972cc 2.0L DOHC MFI (2001)
Park Gear: Testing and Inspection
SRS components are located in this area. Review the SRS component locations, precautions, and procedures before performing repairs or service.
1. Remove the instrument panel lower cover.
2. Remove the upper and lower steering column covers.
3. Disconnect the park pin switch connector.
4. Shift the shift lever into [E position, then check for continuity between these connector terminals:
-
'97 - 98 models: No. 1 and No. 3 terminals of the park pin switch connector.
-
'99 - 01 models: No. 3 and No. 4 terminals of the park pin switch/Over-Drive (O/D) switch connector.
There should be continuity.
'97 - 98 MODELS:
'99 - 01 MODELS:
5. Shift the shift lever out of the P position, and check for continuity between the terminals as in step 4. There should be no continuity.
6. If the park pin switch is faulty, replace it.
