CR-V SE 4WD L4-1972cc 2.0L DOHC MFI (2001)
Clutch Master Cylinder: Service and Repair
REMOVAL/INSTALLATION
CAUTION:
-
Do not spill brake fluid on the vehicle; it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
-
Plug the end of the clutch line and reservoir hose with a shop towel to prevent brake fluid from coming out.
1. The brake fluid may be sucked out through the top of the master cylinder reservoir with a syringe.
2. Disconnect the clutch line and reservoir hose from the clutch master cylinder.
3. Remove the reservoir from the engine compartment bulkhead.
4. Pry out the lock pin, and pull the pedal pin out of the yoke. Remove the nuts.