CR-V SE 4WD L4-1972cc 2.0L DOHC MFI (2001)
a. Install the 78 mm shim selected and oil guide plate in the transmission housing.
b. Install the spring washer and washer on the ball bearing.
NOTE:
-
Clean the spring washer, washer and thrust shim thoroughly before installation.
-
Install the spring washer, washer and thrust shim properly.
c. Install the mainshaft in the clutch housing.
d. Place the transmission housing over the mainshaft and onto the clutch housing.
e. Tighten the clutch and transmission housings with several 8 mm bolts.
NOTE: It is not necessary to use sealing agent between the housings.
f.
Tap the mainshaft with a plastic hammer.
g. Slide the mainshaft base over the mainshaft.
