Del Sol L4-1.5L SOHC (1993)
16.
Check that the roof side seal and A pillar weatherstrip are flush at their mating surfaces. If the roof side seal is not flush with the A pillar
weatherstrip, adjust the roof side seal.
17.
Unlock the roof, and lift up the front edge of the roof. Place a shop towel between the roof and A pillar weatherstrip to support the roof.
18.
Adjust the roof side seal by bending its metal core in or out to obtain a flush fit with the A pillar weatherstrip. Remove the shop towel, a check the
fit.
19.
Once a flush fit is obtained, place the shop towel back under the roof at the A pillar weatherstrip. Pull down on the top edge of the roof side seal;
then apply a 50 mm long bead of 3M Ultrapro Auto Body Sealant-Clear (P/N 051135-08302) under the side seal along the top edge.
20.
Apply sealant into the gap on the end of the roof side seal as shown; then remove the shop towel from the front of the roof.