Del Sol L4-1.5L SOHC (1993)
6. Start the engine and allow it to idle for a few minutes, then stop it. Check the fluid level in the modulator reservoir and refill to the MAX level line
if necessary.
7. Turn the Mode Selector switch of the checker to 2.
8. While depressing the brake pedal firmly, push the "Start Test" switch to operate the modulator. There should be kickback on the brake pedal. If
not, repeat steps 5 to 8.
NOTE: Continue to depress the brake pedal firmly when operating the checker.
9. Turn the Mode Selector to 3, 4, and 5. Perform step 8 for each of the test mode positions.
10. Refill the modulator reservoir to the MAX level line and install the reservoir cap.
WARNING: Disconnect the ALB Checker before driving the car. A collision can result from a reduction or complete loss of braking ability, causing
severe personal injury or death.
Without Anti-Lock Brakes
Brake Bleeding Sequence
CAUTION:
^
Use only clean DOT 3 or 4 brake fluid.
^
Make sure no dirt or other foreign matter is allowed to contaminate the brake fluid.
^
Do not mix different brands of brake fluid as they may not be compatible.
^
Do not spill brake fluid on the car, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
NOTE: The reservoir on the master cylinder must be full at the start of bleeding procedure, and checked after bleeding each brake caliper. Add fluid as
required. Use only clean DOT 3 or 4 brake fluid.
Brake Bleeder Screw Location (Front)