Del Sol Si VTEC L4-1590cc 1.6L DOHC (VTEC) MFI (1997)
Engine Oil: Service and Repair
REPLACEMENT
CAUTION: Remove the drain plug carefully; hot oil may cause scalding.
1. Warm up the engine.
2. Drain the engine oil.
3. Reinstall the drain plug with a new washer, and refill the engine with the recommended oil.
-
Requirement:
-
API Service Grade: Use "Energy Conserving II" SH grade oil, SAE 5W-30 preferred. You can also use oil from a container that bears the
API CERTIFICATION mark.
-
Capacity:
-
4.0 l (4.2 qts.) at change, including filter.
-
3.7 l (3.9 qts.) at change, without filter.
-
4.8 l (5.1 qts.) after engine overhaul.
-
Change:
-
Every 7,500 miles (12,000 km) or 12 months (Normal Conditions).
-
Every 3,750 miles (6,000 km) or 6 months Severe Conditions).
NOTE: Under normal conditions, the oil filter should be replaced at every other oil change. Under severe conditions. the oil filter should be
replaced at each oil change.
-
The numbers in the middle of the API Service label tell you the oil's SAE viscosity or weight. Select the oil for your car according to this chart:
-
An oil with a viscosity of 5W-30 is preferred for improved fuel economy and year-round protection in the car. You may use a 10W-30 oil if
the climate in your area is limited to the temperature range shown on the chart.
4. Run the engine for more than 3 minutes, then check for oil leakage and oil level.