honda Workshop Repair Guides

Honda Workshop Service and Repair Manuals

Steering Gear|Removal and Installation|Page 5280 > < Steering Gear|Specifications|Page 5277
Page 1
background image

Steering Gear: Service and Repair
Removal and Installation

TOOL REQUIRED 

-

07MAC-SL00200 Ball Joint Remover, 28 mm

NOTE:  Using solvent and a brush, wash any oil and dirt off the valve body unit and its lines, and the end if the gearbox. Blow dry with compressed air.

REMOVAL 

1. Drain the power steering fluid.
2. Raise the front of car and support on safety stands in the proper locations.
3. Remove the front wheels.
4. Remove the driver's airbag assembly and steering wheel.

5. Remove the steering joint cover.

6. Remove the steering joint lower bolt, and disconnect the steering joint by moving the joint toward the column.

Steering Gear|Removal and Installation|Page 5280 > < Steering Gear|Specifications|Page 5277