Del Sol Si VTEC L4-1590cc 1.6L DOHC (VTEC) MFI (1997)
6. Hold the damper shaft, and tighten the 10 mm self-locking nut.
7. Loosely install the damper on the frame with the aligning tab facing inside, then loosely install the two flange nuts.
8. Install the damper fork over the driveshaft and onto the lower arm. Install the front damper in the damper fork so the aligning tab is aligned with
the slot in the damper fork.
9. Loosely install the damper pinch bolt on the top of the damper fork.
10. Loosely install the damper fork bolt, and a new self-locking nut on the bottom of the damper fork.
11. Raise the knuckle with a floor jack until the car just lifts off the safety stand.