Del Sol Si VTEC L4-1590cc 1.6L DOHC (VTEC) MFI (1997)
3. Install the new set ring onto the driveshaft or intermediate shaft groove.
CAUTION: Always use a new set ring whenever the driveshaft is being installed.
4. Insert the inboard end of the driveshaft into the differential or intermediate shaft until the set ring locks in the groove.
5. Install the damper fork over the driveshaft and onto the lower arm. Install the damper in the damper fork so the aligning tab is aligned with the slot
in the damper fork.
6. Loosely install the flange bolt and the new self-locking nut.
NOTE: The bolts and nut should be tightened with the vehicle's weight on the damper.