Del Sol Si VTEC L4-1590cc 1.6L DOHC (VTEC) MFI (1997)
4. If the clearance is more than the service limit, measure the width of the interlock. Standard: 9.9 - 10.0 mm (0.390 - 0.394 inch). If the width is not
within the standard, replace the interlock with a new one. If the width is within the standard, replace the select arm with a new one.
7. Measure the clearance between the select arm and the 10 mm shim. Standard: 0.01 - 0.2 mm (0.0004 - 0.008 inch)
8. If the clearance is not within the standard, select and install the appropriate 10 mm shim for the correct clearance from the chart below.