Del Sol Si VTEC L4-1590cc 1.6L DOHC (VTEC) MFI (1997)
10. Grease all the sliding surfaces of the window regulator where shown.
11. Before removing the motor, mark the location by scribing a line across the sector gear and regulator. Install using the three mounting bolts. Move
the window regulator to the original position by connecting a 12 V battery to the motor.
12. Installation is the reverse of the removal procedure.
13. Roll the glass up and down to see if it moves freely without binding. Also make sure that there is no clearance between the glass and glass run
channel when the glass is closed. Adjust the position of the glass as necessary.
14. Attach the wire harness to the door correctly.
15. When reinstalling the plastic cover, apply adhesive along the edge where necessary to maintain a continuous seal and prevent water leaks.
16. After installation, check for water leaks.
NOTE:
^
Spray water over the roof.
^
Do not spray directly on the sealing area and do not use high-pressure water.